Audio Pci Views

Electronics

The Ensoniq AudioPCI is a PCI-based sound card released in 1997. It was Ensoniq's last sound card product before they were acquired by Creative Technology. The card represented a shift in Ensoniq's market positioning. Whereas the Soundscape line had been made up primarily of low-volume high-end products full of features, the AudioPCI was designed to be very simple, low-cost product to appeal to system OEMs and thus hopefully sell in mass quantities.

The AudioPCI, released in July 1997, was designed primarily to be cheap. In comparison to the wide variety of chips on and sheer size of the older Soundscape boards, the highly integrated two chip design of the AudioPCI is an obvious shift in design philosophy. The board consists only of a very small software-driven audio chip (one of the following: S5016, ES1370, ES 1371) and a companion digital-to-analog converter (DAC). In another cost-cutting move, the previously typical ROM chip used for wavetable patch set storage was replaced with the facility to use system RAM as storage for this audio data. This was made possible by the move to the PCI bus, with its far greater bandwidth and more efficient bus mastering interface when compared to the older ISA bus standard.

AudioPCI, while designed to be cheap, is still quite functional. It offers many of the audio capabilities of the Soundscape ELITE card and surpasses the other Soundscape cards. Notably, AudioPCI supports several digital effects (reverb, chorus, and spatial enhancement) when used with Microsoft Windows 95 and later versions of Windows.

AudioPCI had some surprises for the market. It was one of the first cards to have Microsoft DirectSound3D 4-speaker playback support. The 4-speaker mode is only activated by software supporting the DirectSound3D quadraphonic mode. An oddity is that the rear channel was connected to the same output jack as line input. The jack switches modes if 4-speaker output became active.